Panasonic KX-TDA50 Programming Manual page 548

2.11 [5] Optional Device
SVM Cyclic Tone Detection
Selects the cyclic tone detection mode. Cyclic tone detection is used to determine the end of a call
when an extension user records a greeting message or callers leave voice messages in a message
box.
To change SVM Cyclic Tone Detection, follow the steps below:
1.
Change SVM Cyclic Tone Detection.
2.
Set the status of the SVM2 card to "OUS", then "INS".
Default
Fixed
Value Range
Fixed: The number of times of a tone pattern (a set of tone-on and tone-off) that the PBX receives is
fixed to 4 times in the ranges of:
A
B
A B , = 100–1300 ms,
Option: The tone pattern that the PBX receives is optional as specified in SVM Cyclic Tone Option
on this screen.
Maintenance Console Location
2.11.5 [5-3-3] Voice Message—SVM (KX-TDA50 only)
Programming Manual References
None
Feature Manual References
1.16.5 SVM (Simplified Voice Message)
SVM Cyclic Tone Option—Tone On Maximum Time
Specifies the maximum duration of the cyclic tone that will be recognised by the PBX. When the tone
sent from the telephone company is shorter than the value set here, the PBX recognises it as a tone-
on.
Note that this option can only be set when SVM Cyclic Tone Detection on this screen is set to
"Option".
To change SVM Cyclic Tone Option, follow the steps below:
1.
Change SVM Cyclic Tone Option.
2.
Set the status of the SVM2 card to "OUS", then "INS".
Default
600 ms
Value Range
200 + 20 × n (n=1–390) ms
548 PC Programming Manual
C C
C
D D
= A 90 ms,
C
D
= 90 ms
D B