10-3] Did Table (Kx-Tda100/Kx-Tda200/Kx-Tda600 Only) - Panasonic KX-TDA50 Programming Manual

Feature Manual References
1.4.5 DID (Direct Inward Dialing)
1.13.12 PRIVATE NETWORK FEATURES
DID/TIE—Additional Dial
Specifies the number to be added to the incoming called number in the place of the removed digits
for DID distribution or for TIE line service.
With the KX-TDA50, this parameter is shown as TIE—Remove Digit.
Default
Not stored.
Value Range
Max. 8 digits (consisting of 0–9, *, and #)
Maintenance Console Location
2.16.2 [10-2] DIL Table & Port Settings
Programming Manual References
None
Feature Manual References
1.4.5 DID (Direct Inward Dialing)
1.13.12 PRIVATE NETWORK FEATURES

2.16.3 [10-3] DID Table (KX-TDA100/KX-TDA200/KX-TDA600 only)

Incoming CO line calls with DID numbers can be distributed to specific destinations. Each DID
number has a destination programmed for each time mode (day/lunch/break/night).
When CLI distribution is enabled for a DID number, incoming CO line calls with that DID number will
be distributed to the CLI destinations (instead of the DID destinations) if the caller's identification
number is found in the System Speed Dialing Table, which is used as the Caller ID Table. CLI
distribution can be enabled or disabled for each time mode (day/lunch/break/night) on a DID number
basis.
A maximum of 1000 DID numbers can be programmed with other related parameters. 100 numbers
are displayed at a time. To display other sets of numbers, click the applicable tab.
To assign DID destination numbers, enter directly or click Destination Setting (see 2.1.6 Extension
Number Setting). It is possible to program DID numbers and DID destinations in each time mode
(day/lunch/break/night) for a set of locations in series at once by clicking Automatic Registration, or
to program DID names for a set of locations in series at once by clicking Name Generate.
DID Number
Specifies the DID number.
Default
Not stored.
2.16 [10] CO & Incoming Call
PC Programming Manual 609