Test Operation Mode - Mitsubishi melservo-j2 series Installation Manual

2. OPERATION
Indication list
Indication
(Note 1)
(Note 1)
(Note 1)
(Note 2)
(Note 2)
(Note 3)
(Note 1)
Note:1. # : Axis number (1 to 8: Axis number, 0: Test operation mode)
2. : Warning number
3. : Alarm number
4. If Ab remains shown after the servo system controller power is switched on, possible causes are as follows:
1) The axis number set to the servo system controller is not the same as the axis number set with SW1 of the servo
amplifier.
2) PWB fault in the servo amplifier or communication fault with the servo system controller. In this case, indications
change as follows:
3) Bus cable fault
4) Servo system controller failure
5. Requires the set-up software.
State
Servo system controller power is off after the servo amplifier power has been
Initializing
switched on.
Servo system controller power was switched off while the servo amplifier
Initializing
power was on. (Note 4)
Initializing Communication between servo system controller and servo amplifier started.
Initializing Initial parameters were received.
Initialized
Ready off Ready off command was received.
Servo off Servo off command was received.
Servo on Servo on command was received.
Warning Warning number which occurred is shown.
Alarm Alarm number which occurred is shown.
CPU error
Jog operation, positioning operation, programmed operation, DO forced output
(Note 5)

Test operation mode

Motor-less operation
Description
2 - 7