Table of Contents
Advertisement
4. INSTALLATION
CAUTION
4 - 1 Servo amplifier
CAUTION
(1) Environmental conditions
Environment
Ambient temperature
Ambient humidity
Storage temperature
Storage humidity
Ambient
Altitude
Vibration
1. Stacking in excess of the limited number of products is not allowed.
2. Install the equipment to incombustibles. Installing them directly or close to
combustibles will led to a fire.
3. Install the equipment in a load-bearing place in accordance with this Installation
Guide.
4. Do not get on or put heavy load on the equipment to prevent injury.
5. Use the equipment within the specified environmental condition range.
6. Provide an adequate protection to prevent screws, metallic detritus and other
conductive matter or oil and other combustible matter from entering the servo
amplifier.
7. Do not block the intake/exhaust ports of the servo amplifier. Otherwise, a fault
may occur.
8. Do not subject the servo amplifier and servo motor to drop impact or shock loads
as they are precision equipment.
9. Do not install or operate a faulty servo amplifier or servo motor.
10. When the product has been stored for an extended period of time, consult
Mitsubishi.
1. The equipment must be installed in the specified direction. Otherwise, a fault may
occur.
2. Leave specified clearances between the servo amplifier and control box inside
walls or other equipment.
0 to 55 [ ] (non-freezing)
32 to 131 [ ] (non-freezing)
90%RH or less (non-condensing)
20 to 65 [ ] (non-freezing)
4 to 149 [ ] (non-freezing)
90%RH or less (non-condensing)
Indoors (no direct sunlight)
Free from corrosive gas, flammable gas, oil mist, dust and dirt
Max. 1000m (3280 ft) above sea level
2
5.9 [m/s
] or less
2
19.4 [ft/s
] or less
Conditions
4 - 1
Advertisement
Table of Contents
