Lenovo System x3650 M5 Installation And Service Manual page 351

4000001d-00000000 Watchdog [arg1] Failed to
Capture Screen.
Explanation: This message is for the use case where
an operating system error has occurred and the screen
capture failed.
May also be shown as 4000001d00000000 or
0x4000001d00000000
Severity: Error
Alert Category: System - other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0029
SNMP Trap ID: 22
Automatically notify Support: No
User response: Complete the following steps until the
problem is solved:
1. Reconfigure the watchdog timer to a higher value.
2. Make sure that the IMM Ethernet over USB
interface is enabled.
3. Reinstall the RNDIS or cdc_ether device driver for
the operating system.
4. Disable the watchdog. Check the integrity of the
installed operating system.
5. Update the IMM firmware. Important: Some cluster
solutions require specific code levels or coordinated
code updates. If the device is part of a cluster
solution, verify that the latest level of code is
supported for the cluster solution before you update
the code.
4000001e-00000000 Running the backup
Management Controller [arg1] main
application.
Explanation: This message is for the use case where a
Management Controller has resorted to running the
backup main application.
May also be shown as 4000001e00000000 or
0x4000001e00000000
Severity: Warning
Alert Category: System - other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0030
SNMP Trap ID: 22
Automatically notify Support: No
User response: Update the IMM firmware. Important:
Some cluster solutions require specific code levels or
coordinated code updates. If the device is part of a
cluster solution, verify that the latest level of code is
supported for the cluster solution before you update
the code.
4000001d-00000000 • 40000021-00000000
4000001f-00000000
Explanation: This message is for the use case where a
Management Controller firmware version does not
match the server.
May also be shown as 4000001f00000000 or
0x4000001f00000000
Severity: Error
Alert Category: System - other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0031
SNMP Trap ID: 22
Automatically notify Support: No
User response: Update the IMM firmware to a version
that the server supports. Important: Some cluster
solutions require specific code levels or coordinated
code updates. If the device is part of a cluster solution,
verify that the latest level of code is supported for the
cluster solution before you update the code.
40000020-00000000
Explanation: This message is for the use case where a
Management Controller has been reset due to a user
restoring the configuration to default values.
May also be shown as 4000002000000000 or
0x4000002000000000
Severity: Info
Alert Category: none
Serviceable: No
CIM Information: Prefix: IMM and ID: 0032
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is
required.
40000021-00000000
Explanation: This message is for the use case where a
Management Controller clock has been set from the
Network Time Protocol server.
May also be shown as 4000002100000000 or
0x4000002100000000
Appendix A. Integrated management module II (IMM2) error messages
Please ensure that the
Management Controller [arg1] is flashed
with the correct firmware. The
Management Controller is unable to
match its firmware to the server.
Management Controller [arg1]
Reset was caused by restoring default
values.
Management Controller [arg1]
clock has been set from NTP server
[arg2].
337