Lenovo System x3650 M5 Installation And Service Manual page 626

I.11002 • I.1800E
Attention:
1. When you press Ctrl+Alt+Delete on F1 setup menu panel, the system will
2. Most F1 Setup settings, which can be load default, are chipset related items or
The following is the list of the UEFI/POST error codes and suggested actions to
correct the detected problems.
I.11002 [I.11002]
Explanation: A processor mismatch has been detected
between one or more processors in the system. One or
More Mismatched Processors Detected
Severity: Error
User response: Complete the following steps:
1. This message could occur with messages about
other Processor configuration problems. Resolve
those messages first.
2. If the problem persists, ensure that matching
processors are installed (i.e., matching option part
numbers, etc)
3. Verify that the Processor's are installed in the
correct sockets according to the service information
for this product. If not, correct that problem.
4. Check IBM support site for an applicable service
bulletin or UEFI firmware update that applies to
this processor error.
5. (Trained Service technician only) Replace
mismatching processor. Inspect Processor socket and
replace the system board first if socket is damaged.
I.1800A [I.1800A]
Explanation: A mismatch has been detected between
the speed at which a QPI link has trained between two
or more processor packages. Processors have
mismatched Bus Speed
Severity: Error
User response: Complete the following steps:
Verify that the processor is a valid option that is
1.
listed as a Server Proven device for this system. If
not, remove the Processor and install one listed on
the Server Proven website.
2. Verify that matching processors are installed in the
correct processor sockets. Correct any mismatch
found.
3. Check the IBM support site for an applicable
service bulletin or firmware update that applies to
this processor error.
612
Lenovo System x3650 M5 Type 5462: Installation and Service Guide
reboot automatically and ask you to enter password again.
less user input required items. However, when adjusting the iSCSI settings,
please be aware that the iSCSI configurations cannot be restored to default.
This is to avoid iSCSI items losing its configurations, which may result in the
system not being able to boot to the operating system.
(Trained Service technician only) Replace the
4.
Processor. Inspect Processor socket and replace the
system board first if socket is damaged
I.1800C [I.1800C]
Explanation: A cache type mismatch has been
detected for one or more processor packages.
Processors have one or more cache levels with
mismatched type
Severity: Error
User response: Complete the following steps:
1. Verify that matching processors are installed in the
correct processor sockets. Correct any mismatch
found.
2. Check the IBM support site for an applicable
service bulletin or firmware update that applies to
this processor error.
3. (Trained technician only)Replace the system board
I.1800D [I.1800D]
Explanation: A cache associativity mismatch has been
detected for one or more processor packages.
Processors have one or more cache levels with
mismatched associativity
Severity: Error
User response: Complete the following steps:
1. Verify that matching processors are installed in the
correct processor sockets. Correct any mismatch
found.
2. Check the IBM support site for an applicable
service bulletin or firmware update that applies to
this processor error.
3. (Trained technician only)Replace the system board
I.1800E [I.1800E]
Explanation: A processor model mismatch has been
detected for one or more processor packages.
Processors have mismatched Model Number
Severity: Error