Lenovo System x3650 M5 Installation And Service Manual page 271

installing the SD adapter in your compute node. See the documentation that comes
with the SD adapter and "Using the Setup utility" on page 47 for information and
instructions.
About this task
To install the SD adapter, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page v and "Installation
guidelines" on page 294.
2. Turn off the server, and disconnect all power cords and external cables.
3. Remove the top cover (see "Removing the top cover" on page 147).
4. Remove the riser-card assembly 2 (See "Removing a riser-card assembly" on
page 183).
5. Insert the SD cards.
6. Align the SD adapter with the alignment pin and the connector; then, lower the
SD adapter and push it until it is firmly seated.
7. Fasten two screws.
SD adapter
4
3
Connector
Figure 205. SD adapter installation
8. See the http://www.ibm.com/support/entry/portal/
docdisplay?lndocid=MIGR-5096845, that comes with the option, for information
about how to configure the SD adapter.
9. Turn on the peripheral devices and the server.
Removing the LCD system information display panel
Use this information to remove the LCD system information display panel.
About this task
Removing the LCD panel assembly on a 3.5-inch model
SD 2
4
Alignment pin
Chapter 5. Removing and replacing components
1
SD 1
257