Lenovo System x3650 M5 Installation And Service Manual page 214

Expansion-slot cover
Figure 130. Adapter installation
10. Replace the rear two hard-disk-drive kit in the server (see "Replacing the rear
11. Reinstall the top cover (see "Replacing the top cover" on page 148).
12. Slide the server into the rack.
13. Reconnect the power cords and any cables that you removed.
14. Turn on the peripheral devices and the server.
Removing a RAID adapter battery/flash power module
Use this information to remove a RAID adapter battery/flash power module.
About this task
If a RAID adapter battery / flash power module is installed near the fan cage and
you need to replace it, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page v and "Installation
2. Turn off the server and peripheral devices and disconnect all power cords.
200
Lenovo System x3650 M5 Type 5462: Installation and Service Guide
3. Remove the server top cover (see "Removing the top cover" on page 147).
4. Remove the rear two hard-disk-drive kit (see "Removing the rear two
hard-disk-drive kit" on page 203).
1 Slide the retention bracket; then, 2 rotate it to the open position.
5.
6. Align the adapter with the slot on the rear two hard-disk-drive kit.
3 Press the adapter firmly into the slot on the rear two hard-disk-drive kit.
7.
Bracket
Adapter
8. Connect any required cables to the adapter.
Attention:
v When you route cables, do not block any connectors or the ventilated space
around any of the fans.
v Make sure that cables are not routed on top of components under the rear
two hard-disk-drive kit.
v Make sure that cables are not pinched by the server components.
9. Perform any configuration tasks that are required for the adapter.
two hard-disk-drive kit" on page 204).
guidelines" on page 294.
Rear two hard-disk-drive kit
1
2
3
Adapter connector