2. Turn off the server and peripheral devices and disconnect the power cords and
3. If the server has been installed in a rack, press down on the left and right side
Figure 69. Top cover removal
4.
5. If you are instructed to return the top cover, follow all of the packaging
Replacing the top cover
Use this information to replace the server top cover.
About this task
To replace the server top cover, complete the following steps:
Procedure
1. Make sure that all cables, adapters, and other components are installed and
2. Place the cover-release latch in the open (up) position.
3. Position the top cover on top of the server.
148
Lenovo System x3650 M5 Type 5462: Installation and Service Guide
all external cables, if necessary.
Note: If you need to view any LEDs on the system board or front panel, please
do so before you disconnect the power.
latches and slide the server out of the rack enclosure until both slide rails lock..
1 Push the cover-release latch back, 2 then lift it up. Slide the cover back,
and 3 then lift off the server. Set the cover aside.
Attention: For proper cooling and airflow, replace the server cover before you
turn on the server.
instructions, and use any packaging materials for shipping that are supplied to
you.
seated correctly and that you have not left loose tools or parts inside the server.
Also, make sure that all internal cables are correctly routed.
Important: Before you slide the top cover forward, make sure that all the tabs
and the pins on the top and side of the top cover engage the chassis correctly.
3
2
1
Cover-release latch