Removing A Memory Module - Lenovo System x3650 M5 Installation And Service Manual

Drive retainer clip
Figure 93. Optical drive installation
10. Connect the optical drive cable (see "Replacing the optical drive cable" on
11. Reconnect the power cords and any cables that you removed.
12. Turn on the peripheral devices and the server.

Removing a memory module

Use this information to remove a memory module.
About this task
To remove a dual inline memory module (DIMM), complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page v and "Installation
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the top cover (see "Removing the top cover" on page 147).
4. Remove the air baffle (see "Removing the air baffle" on page 149).
5. Carefully open the retaining clips on each end of the DIMM connector and
168
Lenovo System x3650 M5 Type 5462: Installation and Service Guide
page 162).
guidelines" on page 294.
remove the DIMM.
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, open and close the clips gently.