Lenovo System x3650 M5 Installation And Service Manual page 276

Figure 215. LCD panel assembly cable routing
11. Replace the top cover (see "Replacing the top cover" on page 148).
12. Slide the server into the rack.
13. Reconnect the power cords and any cables that you removed.
14. Turn on the peripheral devices and the server.
Removing the LCD system information display panel on a 2.5-inch model
To install the LCD system information display panel into a media cage that is
pre-configured without a LCD system information display panel on a 2.5-inch
model, complete the following steps.
262
Lenovo System x3650 M5 Type 5462: Installation and Service Guide
Note: To connect the LCD panel assembly cable on the system board, press
evenly on the cable. Pressing on one side of the cable might cause damage to
the cable or connector.
1. Read the safety information that begins on "Safety" on page v and
"Installation guidelines" on page 294.
2. Turn off the server and peripheral devices and disconnect the power cords
and all external cables, if necessary.
3. Remove the top cover (see "Removing the top cover" on page 147).
4. Remove the fan cage assembly"Removing the fan cage assembly" on page
175).
5. Remove the media cage (see "Removing the media cage" on page 179),
6. A separate bezel is needed if your media cage has a bezel without the opening
and buttons for the LCD panel, To remove the media cage bezel, complete the
following steps:
Operator information /
LCD panel connector
Operator information /
LCD panel cable
LCD panel connector