Controlling The Signal Contact - Hirschmann RS20 User Manual

Operation diagnosis

9.3.1 Controlling the signal contact

With this mode you can remotely control every signal contact individually.
Application options:
Simulation of an error during SPS error monitoring.
Remote control of a device via SNMP, such as switching on a camera.
Select the Diagnostics:Signal Contact 1/2) dialog.
In the "Mode Signal contact" frame, you select the "Manual setting"
mode to switch the contact manually.
Select "Opened" in the "Manual setting" frame to open the contact.
Select "Closed" in the "Manual setting" frame to close the contact.
enable
configure
signal-contact 1 mode manual Select the manual setting mode for signal contact
signal-contact 1 state open
signal-contact 1 state closed Close signal contact 1.
Basic Configuration L2P
Release 4.2 07/08
9.3 Out-of-band signaling
Switch to the Priviledged EXEC mode.
Switch to the Configuration mode.
1.
Open signal contact 1.
169