Network load control
7.1 Direct packet distribution
With direct packet distribution, you protect the device from unnecessary net-
work loads. The device provides you with the following functions for direct
packet distribution:
Store-and-forward
Multi-address capability
Aging of learned addresses
Static address entries
Disabling the direct packet distribution
7.1.1 Store-and-forward
All data received by the device is stored, and its validity is checked. Invalid
and defective data packets (> 1,502 bytes or CRC errors) as well as frag-
ments (< 64 bytes) are rejected. Valid data packets are forwarded by the
device.
7.1.2 Multi-address capability
The device learns all the source addresses for a port. Only packets with
unknown addresses
these addresses or
a multi/broadcast address
in the destination address field are sent to this port. The device enters
learned source addresses in its filter table
address
entries").
92
7.1 Direct packet distribution
(see on page 94 „Entering static
Basic Configuration L2P
Release 4.2 07/08