Hirschmann RS20 User Manual page 208

Setting up configuration environment
Check the fingerprint to protect yourself from unwelcome guests. Your fin-
gerprint is located in the "Key" frame of the PuTTY key generator
fig. 79)
If the fingerprint matches your key, click "Yes".
PuTTY will display another security alert message for the warning threshold
set.
Figure 81: Security alert prompt for the warning threshold set
Click "Yes" for this security alert message.
To suppress this message for future connection set-ups, select "SSH" in the
"Category" frame before you set up a connection in PuTTY. In the "Encryp-
tion options" frame, select "DES" and then click "Up" until "Des" is above the
line "---warn below here --". In the "Category" frame, go back to Session and
set up a connection in the usual way.
The OpenSSH Suite offers experienced network administrators a further op-
tion of accessing your device via SSH. To set up the connection, enter the
following command:
ssh admin@149.218.112.53 -cdes
admin represents the user name
149.218.112.53 is the IP address of your device.
-cdes specifies the encryption for SSHv1
208
A.4 Preparing access via SSH
Basic Configuration L2P
(see
Release 4.2 07/08