Hirschmann RS20 User Manual page 120

Network load control
Class of Service Trust Mode: IP DSCP
Always assign the DSCP priority to received IP data pack-
ets globally (RS20/RS30/RS40, MS20/MS30, RSR20/RSR40,
MACH 1000 and OCTOPUS)
Select the QoS/Priority:Global dialog.
Select trustIPDSCP in the "Trust Mode" line.
Configuring Layer 2 management priority
Configure the VLAN ports to which the device sends management
packets as a member of the VLAN that sends data packets with a tag
(see on page 128 „Configuring
Select the QoS/Priority:Global dialog.
In the line VLAN priority for management packets you enter
the value of the VLAN priority.
enable
network priority dot1p-vlan
7
exit
show network
System IP Address.............................. 10.0.1.116Subnet
Mask.................................... 255.255.255.0Default
Gateway................................ 10.0.1.200Burned In MAC
Address.......................... 00:80:63:51:7A:80Network Config-
uration Protocol (BootP/DHCP).... NoneDHCP Client ID (same as SNMP
System Name)...... "PowerMICE-518280"Network Configuration Proto-
col HiDiscovery..... Read-WriteManagement VLAN
ID............................. 1Management VLAN Priori-
ty....................... 7Management IP-DSCP Val-
ue....................... 0(be/cs0)Web
Mode....................................... EnableJavaScript
Mode................................ Enable
120
VLANs").
Switch to the Priviledged EXEC mode.
Assign the value 7 to the management priority so
that management packets with the highest priority
are sent.
Switch to the Priviledged EXEC mode.
Displays the management VLAN priority.
7.4 QoS/Priority
Basic Configuration L2P
Release 4.2 07/08