Monitoring Correct Operation Via The Signal Contact - Hirschmann RS20 User Manual

Operation diagnosis
9.3.2 Monitoring correct operation via the signal
contact
Configuring the operation monitoring
Select the Diagnostics:Signal Contact dialog.
Select "Monitoring correct operation" in the "Mode signal contact"
frame to use the contact for operation monitoring.
In the "Monitoring correct operation" frame, you select the events
you want to monitor.
To monitor the temperature, you set the temperature thresholds in
the Basics:System dialog at the end of the system data.
enable
configure
signal-contact 1 monitor all Includes all the possible events in the operation
signal-contact 1 trap enable Enables a trap to be sent if the status of the oper-
Displaying the signal contact
The device gives you three options for displaying the status of the signal
contact:
LED display
display in the Web-based interface
query in the Command Line Interface.
170
9.3 Out-of-band signaling
Switch to the Priviledged EXEC mode.
Switch to the Configuration mode.
monitoring.
ation monitoring changes.
Basic Configuration L2P
Release 4.2 07/08