Loading Settings - Hirschmann RS20 User Manual

Loading/saving settings

3.1 Loading settings

When it is restarted, the device loads its configuration data from the local
non-volatile memory, once you have not activated BOOTP/DHCP and no
ACA is connected to the device.
During operation, the device allows you to load settings from the following
sources:
the local non-volatile memory
the AutoConfiguration Adapter. If an ACA is connected to the device, the
device always loads its configuration from the ACA.
a file in the connected network (= state on delivery)
a binary file or an editable and readable script on the PC and
the firmware.
Note: When loading a configuration, do not access the device until it had
loaded the configuration file and has made the new configuration settings.
Depending on the complexity of the configuration settings, this procedure
can take 10-200 seconds.
54
3.1 Loading settings
Basic Configuration L2P
Release 4.2 07/08