Operation Diagnostics
9.3.1 Manual setting the signal contact
This mode gives you the option of remote switching each signal individually.
Application options:
D
Simulation of an error during SPS error monitoring.
D
Remote control of a device via SNMP, such as switching on a camera..
V Select the Diagnostics:Signal Contact 1/2 dialog.
V Select "Manual setting" in the "Mode Signal Contact" frame, to switch
the contact manually.
V Select "Opened" in the "Manual setting" frame to open the contact.
V Select "Closed" in the "Manual setting" frame to close the contact.
Configure signal contact
enable
configure
signal-contact 1 mode manual
signal-contact 1 state open
signal-contact 1 state closed
Basic - L3P
Release 3.1 06/07
9.3 Out-of-band signaling
Switch to the privileged EXEC mode.
Switch to the configuration mode.
Selects the manual setting mode for signal
contact 1.
Opens signal contact 1.
Closes signal contact 1.
175