Hirschmann RS20 User Manual page 33

Entering the IP Parameters
In accordance with the
page 18, set up a connection with the device.
The start screen appears.
NOTE: Enter '?' for Command Help. Command help displays all options
that are valid for the 'normal' and 'no' command forms.
the syntax of a particular command form, please consult the
documentation.
(Hirschmann PowerMICE) >
Change to the Privileged EXEC mode by entering
enable and pressing the Enter key.
Disable DHCP by entering network protocol none and then pressing
the Enter key.
Enter the IP parameters with
network parms <IP address> <network mask> [<Gateway>]
and press the Enter key.
Local IP address
On delivery, the device has the local IP address 0.0.0.0.
Network mask
If your network has been divided up into subnetworks, and if these are
identified with a network mask, then the network mask is to be entered
here.
The default setting of the network mask is 0.0.0.0.
IP address of the gateway
This entry is only required if the device and the management station or
tftp server are located in different subnetworks
ple of how the network mask is
Enter the IP address of the gateway between the subnetwork with the
device and the path to the management station.
The default setting of the IP address is 0.0.0.0.
Basic Configuration L2P
Release 4.2 07/08
2.2 Entering IP parameters via CLI
„Opening the Command Line Interface"
used").
dialog on
For
(see page 30 „Exam-
33