Web-Based Ip Configuration - Hirschmann RS20 User Manual

Entering the IP Parameters

2.8 Web-based IP configuration

With the Basics:Network dialog you define the source from which the
device gets its IP parameters after starting, and you assign the IP parameters
and VLAN ID and configure the HiDiscovery access.
Figure 16: Network parameters dialog
Under "Mode", enter where the device is to obtain its IP parameters:
In the BOOTP mode, the configuration is via a BOOTP or DHCP serv-
er on the basis of the MAC address of the device
ting up DHCP/BOOTP
In the DHCP mode, the configuration is via a DHCP server on the ba-
sis of the MAC address or the name of the device
ting up DHCP/BOOTP
In the local mode the net parameters in the device memory are used.
Enter the parameters on the right according to the selected mode.
Basic Configuration L2P
Release 4.2 07/08
2.8 Web-based IP configuration
server").
server").
(see page 190 „Set-
(see page 190 „Set-
49