Hirschmann RS20 User Manual page 57

Loading/saving settings
Figure 17: Load/store dialog
enable
copy tftp://149.218.112.159/
switch/config.dat
nvram:startup-config
Note: The loading process started by DHCP/BOOTP
tem configuration via BOOTP")
locally" in the "Load" frame. If you get an error message when saving a
configuration, this could be due to an active loading process. DHCP/BOOTP
only finishes a loading process when a valid configuration has been loaded.
If DHCP/BOOTP does not find a valid configuration, then finish the loading
process by loading the local configuration in the "Load" frame.
Basic Configuration L2P
Release 4.2 07/08
Switch to the Priviledged EXEC mode.
The device loads the configuration data from a
tftp server in the connected network.
shows the selection of "from URL & save
3.1 Loading settings
(see on page 40 „Sys-
57