Using the verification tone
With base station
2020, 2030, 3020, 3025
2015 plus, 2016 plus,
2060isdn, 3010, 3015,
as well as all Gigaset
4000 base stations
1) Also applies to enhanced, pocket and micro versions.
2) Prerequisite: the handset has been switched on in the extended Gigaset Repeater area
and has not left the reception ranges (it has not been switched off again or the battery
3) Prerequisite: preparatory steps described on page 15 and page 16 have been carried out.
The verification tone enables you to establish whether or
not the handset is working in the extended area of the
Gigaset Repeater. This tone is audible on the activated
handset as long as the unit is connected to the Gigaset
Carry out the procedure described below on your Gigaset
Repeater in order to switch the verification tone on and
Switch off the unit (disconnect the power plug)
Switch on for 1 to 5 seconds and switch it off again.
Switch on again. If the left LED on the unit is flashing
slowly, switch it off again.
Switch it on again. The verification tone is then activated
This table indicates whether or not a call is continued
when you move from one reception range to another:
Roaming with the handset
to base station