Table of Contents
Advertisement
SME 211 Power Up Procedure
NOTE: Before powering the SME 211, ensure that all necessary devices are connected
Connect the power cord to a 100 to 240 VAC supply (see
page 8).
Front Panel Lockout (Executive Mode)
To prevent accidental changes to front panel menu settings, enable executive mode.
Executive mode can be enabled and disabled from the front panel. Press the Stop and
Mask buttons simultaneously for 5 seconds. The
change and all LEDs are turned off when Executive mode is enabled.
Executive Mode can also be enabled or disabled from the web pages or using SIS (see
System Settings
When executive mode is enabled, any attempts to utilize the front panel buttons triggers the
Stream, Pause, Stop and Mask button LEDs to blink 3 times.
When executive mode is active, all functions and adjustments can still be made via USB,
RS-232, Ethernet, and web interface controls (see
starting on page 58).
NOTE: Control buttons indicate the current streaming status regardless of executive
Setting the IP Address Using SIS Commands
Using the front panel config port, you can use the following SIS commands to enable
and disable DHCP, view and configure the IP address, and change the subnet mask. Use
DataViewer, available from www.extron.com, on a control PC via any of the control system
connections to send commands to the SME 211 and view the results.
SIS Command
E CI }
E 1DH }
E 0DH }
E 2BOOT }
E 192.168.254.254CI }
E 255.255.0.0CS }
NOTE:
properly. Connected devices do not need to be powered on.
on page 47 or
mode.
}
= Carriage return (no line feed, hex 0D).
Power Connection
button flashes to confirm the mode
Mask
Front Panel Lock (Executive Mode)
Remote Communication and Control
Description
View the current IP address
Enable DHCP
Disable DHCP
Restart the network interface and apply changes
Set the default IP address
Set the default subnet mask
on
on page 68
SME 211 • Introduction
15
Advertisement
Table of Contents
