Table of Contents
Advertisement
RS-232
DSC Rear Panel
RS-232 Port
Tx Rx
G
1 2 3
Figure 13.
See
SIS Commands
port.
Connecting to the USB Config Port
The USB mini-B USB Config port is located on the DSC front panel. It can be used to
configure the DSC via the PCS software or SIS commands.
1.
Use a USB A-to-mini-B cable to connect the DSC USB Config port to a USB port on
a computer.
DSC HD-HD 4K Plus A Front Panel
Figure 14.
NOTES:
•
For cable that has a drain wire, tie the drain
wire to ground at both ends.
•
Connect a ground wire between the DSC
and the computer or control system.
Ground (G)
Receive (Rx)
Transmit (Tx)
Transmit (Tx)
Receive (Rx)
Connecting to the RS-232 Port
on page 42 for information on sending SIS commands through this
USB
Mini-B
USB Cable
INPUT
OUTPUT
SIGNAL
SIGNAL
CONFIG
HDCP
HDCP
AUDIO
AUDIO
Connecting to the Front Panel USB Config Port
Computer or
Control System
RS-232 Port
USB A
USB
Ports
DSC HD-HD 4K Plus A
MENU
AUTO-
IMAGE
ENTER
HOLD
FOR XGA/720p
DSC HD-HD 4K Plus A Series • Installation
USB 1
Computer
15
Advertisement
Table of Contents
