Table of Contents
Advertisement
Assembling the
satellite modem
components
Follow the steps below and refer to the illustrations
on page 13 through page 15 to assemble the
satellite modem components. Remember that the
receive modem goes on top of the transmit modem.
After assembling the components, install the
software.
Note: Do not connect the USB cable to your
computer until instructed to do so during software
installation.
1. Be sure your power supply is not plugged into
your wall outlet, surge protector, or power
strip.
2. Snap the four clips under the feet of the receive
and transmit modems. Mount the clip so that
the mounting tab slides over the feet on the
bottom of the each modem as shown in
Figure 7.
Note: The transmit modem has a hole at the
center of the four feet. The mounting clip tabs
snap into place when they are properly aligned
over this hole.
Figure 7: Install clips
Installing the system
13
Advertisement
Table of Contents
