Configuring Communication
IR Communication
In certain situations, the MVP-5200i may be used as an infrared remote device for other AMX controllers. The
device can transmit IR over 20 feet (6.10 m) from the panel at frequencies of 38KHz, 455KHz, and 1.2MHz.
IR receivers and transmitters on G4 panels share the device address number of the panel.
The MVP-5200i includes an IR transmitter for communication between the device and the NetLinx Master
and between separate devices. The transmitter is located behind the IR Emitter Panel on the rear of the device
(FIG. 16).
FIG. 16
IR transmitter window on the MVP-5200i-GW
Modero Setup and System Settings
All AMX Modero panels, including the MVP-5200i, feature on-board Setup pages. Use the options in the
Setup pages to access panel information and make various configuration changes.
Accessing the Setup and Protected Setup Pages
1.
At any time, press down and hold the center button of the navigation wheel for 3-5 seconds. This opens a
release notice to release the button immediately to open the Setup page (FIG. 17).
FIG. 17
Setup page
2.
Press the Protected Setup button. This opens a keypad for entry of the password to allow access to the
Protected Setup page (FIG. 18). Enter the device's password and press Done to proceed.
20
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom
IR Emitter Panel