System Settings - Usb; Calibrate Page - AMX MVP-9000i Operation And Reference Manual

Protected Setup Pages

System Settings - USB

The USB tab (FIG. 88) controls the ability for the MVP-9000i to connect to a network via a USB connection.
FIG. 88
System Settings page - USB tab
The features on the USB tab include:
System Settings - USB Tab
Back:
WiFi/Wired icon:
Connection Status icon:
DHCP/Static:
IP Address:
Subnet Mask

Calibrate Page

The Calibrate page (FIG. 89) allows you to calibrate the touch panel for accurate button selection.
FIG. 89 Calibrate page
1.
From the Protected Setup page, touch the Calibration button to open the Calibrate page.
The Calibrate page may also be accessed by holding the lower left capacitive touch
button and the directional pad for 6 seconds, or by pressing the Reset button on the
left side of the device for 9 seconds.
2.
Press the crosshairs in turn. If the crosshairs are not touched within ten seconds, the MVP-9000i will return to the
Protected Setup page.
82
Saves all changes and returns to the previous page.
The icon to the left of the Connection Status Icon displays whether the current
connection to the Master is Wireless (image of a radio antenna) or Wired (image
of three networked computers).
The icon in the upper-right corner of each Protected Setup page provides a
constant visual indication of current connection status.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx
Master.
This field will always display Static.
Displays the secondary IP address for the panel. The last series of digits may
be edited, with a host number added between 2 and 254.
Displays the subnet mask address for the panel.
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom