Connections And Wiring; Recharging; Cleaning The Mvp-Tcs-52 - AMX Modero ViewPoint MVP-5200i Operation/Reference Manual

Accessories
Charging station
rear support
FIG. 6 MVP-5200i in MVP-TCS-52-GB Table Charging Station

Connections and Wiring

The PS3.0 is used to supply power to the MVP-5200i by routing incoming power through the connector pins
and charge the device's internal battery

Recharging

To recharge the MVP-5200i, slide the device into the Table Charging Station cradle bottom-first and make sure
the device is fully seated in the Charging Station. The charger pins in the bottom of the cradle (FIG. 7) must be
in contact with the connector on the bottom of the MVP-5200i for it to start recharging. The MVP panel will
stop recharging automatically once the battery has achieved its maximum charge.
FIG. 7 MVP-TCS-52-GW Table Charging Station - Rear

Cleaning the MVP-TCS-52

You should clean the Table Charging Station after each day's use to maintain the device's appearance. Always
use a clean cotton cloth and a spray bottle containing water or a vinegar-based cleaner, as alcohol-based
cleaners can damage the device. Do not directly spray the device: instead, spray the cloth to prevent moisture
from collecting on the charger pins. Do NOT use an abrasive of any type to clean the Table Charging Station,
as this may permanently damage or remove the device's finish.
10
Charging Station cradle
Charger pins
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom
MVP-5200i
Table Charging
Station