Recharging; Using The Usb Ports; Undocking The Touch Panel; Cleaning The Mvp-Tds-9 - AMX MVP-9000i Operation And Reference Manual

Recharging

To recharge the MVP-9000i, slide the device into the Table Docking Station cradle bottom-first and make sure the device
is fully seated in the Docking Station. The charger pins in the bottom of the cradle (FIG. 9) must be in contact with the
connector on the bottom of the MVP-9000i for it to start recharging. The MVP panel will stop recharging automatically
once the battery has achieved its maximum charge.
FIG. 9 MVP-TDS-9-GW Table Docking Station - Rear

Using the USB ports

The MVP-TDS-9 has two USB ports on the left of the device behind the Docking Station cradle (FIG. 9). These ports
may be used for transferring files to the MVP-9000i, as well as ports for USB-powered accessories.

Undocking the Touch Panel

For information on removing a touch panel locked into the MVP-TDS-9, please refer to the Undocking from the MVP-
TDS-9 or MVP-WDS-9 on page 22.

Cleaning the MVP-TDS-9

You should clean the MVP-TDS-9 Table Docking Station after each day's use to maintain the device's appearance.
Always use a clean cotton cloth and a spray bottle containing water or a non-ammonia-based cleaner, as alcohol-based
cleaners can damage the device. Do not directly spray the device: instead, spray the cloth to prevent moisture from
collecting on the charger pins. Do NOT use an abrasive of any type to clean the Table Docking Station, as this may
permanently damage or remove the device's finish.
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
Docking Station cradle
Charger pins
USB ports (2)
Locking groove
Accessories
13