Table of Contents
Advertisement
Advice
Disclaimer
All documents are produced and proved with accurancy. Never the less failings can't
be excluded completely. Therefore Busch-Jaeger Elektro GmbH can't take over juristi-
cal responsibility according to the content.
Technical modifications remain always feasable!
9
Logic functions
63/240
9.1.1
Using logic functions
Complex switching sequences can be realised in the Com-
fort Panel using so-called Logic functions which can be
configured in the graphical logic editor of IP Project.
Logic functions essentially consist of logic modules that
are organised into a logic network. Input and output modu-
les are interfaces of the logic network to a KNX or IP-
based network (see section
Notes:
The logic functions are event-controlled. For
every arrival of a telegram at an input module,
all logic modules affected by this event are re-
calculated.
If the recalculation of a logic function is trigge-
red by a telegram input, the input modules are
allocated with the value of the last telegram to
come in.
Time-controlled logic functions automatically
carry out a recalculation after expiry of the
specified time.
Within a logic network, only the five data ty-
Boolean
pes
String
are used instead of the KNX data types.
The logic engine of the Comfort Panel is a ca-
pable and complex tool for a smart and effi-
cient realization of logic networks. However, it
must be kept in mind that a logic network is
triggered on each arriving telegram. That is,
the logic network is re-calculated on each new
telegram and new output telegrams are sent.
When used in an inappropriate way this may
lead to an overload of the KNX bus!
Input and output
Number
Date
Time
,
,
,
modules).
, as well as
Advertisement
Table of Contents
