Table of Contents
Advertisement
20.3.3
KNX input module details
20.3.3.1 Behaviour
Upon receipt of an input telegram from the KNX network via the communication object DP0,
the KNX input module outputs the value of the received telegram to the logical-sided Output 0.
The data type of the incoming telegram is automatically converted to the corresponding internal
data type (see conversion table below).
20.3.3.2 Linking with group addresses
Every KNX input module can be linked with one or multiple group addresses. For this purpose,
it has a DP0 communication object.
In order to link the communication object with group addresses, go to the Objects tab in the
worksheet. Here you will see the communication objects of all input and output modules of your
logic Drag a group address from the Actions area in the library area to the communication object
(see
Add element from
library).
Note:
As data type of the incoming telegram, the data type of the first linked group address on the
DP0 communication object is always adopted. If values outside of the defined data range are
received on the other group addresses, the KNX input module ingnores these values.
20.3.3.3 Extended settings
You can specify the initial value to be used of the KNX input module according to the type of
the linked group address (see above) via the Input value parameter.
Note:
This value is only then used if a logic module linked with the KNX input module is recalcula-
ted, at the KNX input module, however, a KNX telegram was still not received.
20.3.3.4 Conversion table
KNX data type
Data point type Range of values
Internal data type
148/240
Advertisement
Table of Contents
