Assigning Group Addresses (Comfort Panel Communication Objects); Using Comfort Panel Communication Objects - Busch-Jaeger Busch-ComfortTouch Product Manual

19.15 → Assigning group addresses (Comfort Panel
communication objects)
137/240
19.15.1 Using Comfort Panel
communication objects
To establish a connection between a comfort Panel and an actua-
tor or sensor you must assign a group address to the Comfort Pa-
nel in the IP project. For this purpose each Comfort Panel has
several Communication objects.
To do this go to Project level in the work sector and to tab Ob-
jects. Here you see all communication objects of all Comfort Pa-
nels in your project. Now drag a group address from the sector
Actions in the library sector onto a communication object (see
Insert element from library).
A Comfort Panel can have the following communication objects:
User preferences\Temperature unit selection

User preferences\User language

User preferences\Room temperature

door sensor is not used)
User preferences\Outdoor temperature

Screen saver\Screen saver on/off

Screen saver\Screen saver status

Screen saver/Select slide show mode

Screen saver\Select single image mode

Screen saver\Select clock mode

Screen saver\Select weather data mode

Screen saver\Temperature

Screen saver\Air pressure

Screen saver\Air humidity

Screen saver\Wind speed

Screen saver\Wind direction

Screen saver\Brightness

Screen saver\Rain

Display\Backlight enable

(only when in-