Table of Contents
Advertisement
145/240
the left-hand area of the editor's window.
In the view that will be displayed, user levels 1 to 8 are
listed in which you can activate each level individually via
the checkbox. Stage 0 (guest) is permanently activated.
For user levels that are activated the PIN, which is 0000 as
standard, should be changed.
20.2.2.2 Assigning pages and operating
elements to the user levels
With the user levels so defined, you can then configure the
access control for single pages and operating elements.
Then select the entry Assignments in the left window sec-
tion of the editor. In this view all pages and operating ele-
ments are listed that have been created up to now in the
Comfort panel. Also displayed is the user level assigned to
each element. Standard is level 0, which does not require a
PIN. You now have the opportunity to edit the assignment
of the access levels.
In view Default settings and via the checkbox Activate
blips you can set whether a blip is to be played. This signal
sounds as soon as access is denied by the access control.
20.2.2.3 Time interval for a return to
user level 0
You can define a time interval for a return to user level 0.
The authorization status of a user on the Comfort Panel is
limited timewise. After a correct entry of a PIN an internal
timer starts. When the timer has run down, the user's cur-
rent authorization level is withdrawn and he is again log-
ged in as guest. The timer starts anew each time the user
makes an entry on the screen. The length of the time inter-
val can be configured in view Default settings via Automa-
tic block.
Advertisement
Table of Contents
