Table of Contents
Advertisement
Logic functions are deactivated by default.
After activation you can configure following parameters in
theBasic Settings dialog:
The parameter Queue size defines the size of the input buf-
fer of the logic engine.
The parameterOverflow behavior defines how to proceed
if the input buffer is flooded.
Skip new events
elements are to be ignored.
Remove old elements
of new elements old elements are to be remo-
ved from the input queue. In this case the pa-
Elements to remove
rameter
ny of the oldest elements are to be discarded.
Sending delay
The parameter
liseconds the logic engine waits after calculating new
values, until these values are sent.
Please note:
Very low sending delay values may lead to a significantly
increased CPU load.
19.9.8
Activating Remote Desktop
The Comfort Panel can be controlled remotely via the
VNC protocol (Virtual Network Computing). To do this,
you simply need to enter the IP address of the Comfort
Panel in a browser on a PC in the network. You then get
the complete user interface as it is seen on the display of
the Comfort Panel.
It is thus possible to trigger all operating functions remote-
ly and see all information that the Comfort Panel displays
from a different location. The call-up is also possible
through the Internet via VPN, provided that the panel is
connected to a router that has Internet access.
The Remote Desktop does not have a visible application
page on the Comfort Panel. It is therefore activated via
dialogue Basic settings. You can find this setting in the
Additional applications view in the Remote Desktop field.
The Remote Desktop is active when Yes is selected.
After activating, you can configure this application in an
editor (see
Configuring additional
defines that newly received
defines that on retrieval
defines how ma-
defines the time in mil-
applications).
126/240
Advertisement
Table of Contents
