Table of Contents
Advertisement
19.4.3
Setting time interval for deactivating the display
After expiry of a specified time the display of the Comfort Panel can be switched off complete-
ly. Here a time period from the last actuation of the Comfort Panel up to the deactivation of the
display must be set. The two timers for the screen saver (see above) and the deactivation of the
display start simultaneously. If the display is deactivated it will turn itself on again after rene-
wed actuation.
Time intervals can be set in dialogue Basic settings in view Screen saver in the selection list
Stop screen saver and turn off display.
Note:
It is advisable for the screen saver to activate itself first and then after the expiry of a specified
time the display should deactivate itself.
19.4.4
Showing the status bar
While the screen saver is seen on the display, also the status bar can be displayed as on option.
The setting can be made in dialogue Basic settings in view Screen saver in the selection list
Show status bar.
19.4.5
Selecting the screen saver visualisation
The following visualisations are available as screen saver in the selection list Screen saver
mode.
Slide show
Single image
Clock
(analogue or digital clock)
Weather data
Note:
Please observe that images in jpg or png format with a maximum resolution of 1600 *
960 pixels must be present.
19.4.5.1 Settings for the
Slide folder
The folder containing the slide files for the
fied or changed via the setting
Note:
If several slides are to be displayed in a
.jpg
format
into the corresponding slot of the Comfort Panel.
Page transition effect
107/240
(slide show with single images)
(single image)
(weather data)
Slide show
:
.png
or
) must be located on an
:
:
Slide show
Slide folder
.
Slide show
SD multimedia card
can vary. It can be speci-
the respective slide files (in
that is plugged
Advertisement
Table of Contents
