Extended Settings; Conversion Table; Less Or Equal" Module Details; Behaviour - Busch-Jaeger Busch-ComfortTouch Product Manual

20.3.16 "Less or equal" module details

20.3.16.1 Behaviour

The module compares the values at the inputs. If the value of the Input 0 is less than or identical
to the value of the Input 1, the result 1 (logical "true") is output on the Output 0. Otherwise the
output value is 0 (logical "false"). Output 1 always outputs the result inverted.
If necessary, incoming values are converted into the internal data type of the module before the
comparison (see conversion table below). Thus, observe the selection of a correct internal data
type!
The comparison is dependent on the internal data type of the module and is executed in the fol-
lowing way:
Internal data type Comparison rule
Number
Time
Date
String

20.3.16.2 Extended settings

Internal data type
Via the

the module.
Only send with change
Via the

value shall only be sent if the result of the calculation is different to the previ-
ously calculated result.

20.3.16.3 Conversion table

Boolean
(converted)
Boolean ---
Nummer comparison
Time comparison
Date comparison
String length comparison "ComfortPanel" ≤ "priOn" → false
parameter, you can specify the internal data type of
Number DPTTime
(converted) (converted)
true 1 every va-
→
false → 0 lue
Example
5 ≤ 3
16:00 ≤ 15:30
17.07.2009 ≤ 1.1.1970
parameter, you can specify whether an output
-- Current
- time
→ false
→ false
→ false
DPTDate String
(converted) (converted)
Current true
→
date false →
"1"
"0"
174/240