Table of Contents
Advertisement
20.3
→ Configuring Remote Desktop
20.3.1
Using the Remote Desktop
The Comfort Panel can be controlled remotely via the
VNC protocol (Virtual Network Computing). To do this,
you simply need to enter the IP address of the Comfort
Panel in a browser on a PC in the network. You then get
the complete user interface as it is seen on the display of
the Comfort Panel.
It is thus possible to trigger all operating functions remote-
ly and see all information that the Comfort Panel displays
from a different location. The call-up is also possible
through the Internet via VPN, provided that the panel is
connected to a router that has Internet access.
20.3.2
Setting Remote Desktop
If Remote Desktop was activated, you can make settings in
the Application settings dialog. The dialog can be reached
via the parameter section of the respective Comfort Panel
using the button Application settings or via the menu under
Panel > Application settings. Select Remote Desktop in the
left area there.
Note:
The dialog for Application settings can only then be called
up if the software module Remote Desktop has been pre-
viously activated (see
20.3.2.1 Specifying user name and
password
You specify the user name and password that are required
for the access via Remote Desktop via the parameters User
name for remote access and Password for remote access.
20.3.2.2 Setting the time interval for
automatic logging off
The Timeout due to inactivity parameter specifies the time
after which Remote Destop will be ended automatically.
Any time interval can be defined here from 1 second to
1440 seconds. It is possible to deactivate this automatic
logout function with No timeout. For security reasons, the
Remote Desktop should, however, be ended automatically.
Activating additional
applications).
146/240
Advertisement
Table of Contents
