Table of Contents
Advertisement
Example:
A programming telegram to a participator 1.2.4 would not
pass an IP router with address 2.3.0, since a participator
1.2.4 is not located in a line 2.3.
With setting Block , basically all telegrams with a physical
address are blocked.
With the Filter setting, all telegrams with a physical
address are transferred. It does not matter whether they are
located in the subordinate line or not (see example above).
IP --> KNX Broadcast
19.5.3.6
telegrams
The parameter IP --> KNX Broadcast telegrams is used to
block or enable the transfer of Broadcast telegrams (e.g.
telegrams that are transmitted via the KNX multicast
address) from the Main/Area line to the Sub line.
KNX --> IP Broadcast
19.5.3.7
telegrams
The parameter KNX --> IP Broadcast telegrams is used to
block or enable the transfer of Broadcast telegrams (e.g.
telegrams that are transmitted via the KNX multicast
address) from the Sub line to the Main/Area line.
19.5.4
Acknowledgement of
telegrams
19.5.4.1
IP --> KNX Confirmation group
telegrams
The parameterIP --> KNX Confirmation group telegram
specifies when an acknowledgement is sent for receipt of a
group telegram on the Main-/Area line.
At setting Normal an acknowledgement is sent only when
the telegrams were transferred to the subordinate side (e.g.
because the group address is located in the filter table). At
selection All acknowledgements are always sent on the
main/area line after the receipt of a telegram, irrespective
of whether they were transferred to the subordinate side or
not.
Broadcast
(Tab
Broadcast
(Tab
Basis
(Tab
)
)
)
114/240
Advertisement
Table of Contents
