20.3.36 Random value details
20.3.36.1 Behaviour
The module outputs random values from a specific value range on the Output 0. This can occur
cyclically or upon receipt of the value 1 (logical "true") on Input 0 .
The data type of the Input 0 is Boolean. If necessary, incoming values are converted before the
calculation (see conversion table below).
20.3.36.2 Extended settings
Internal data type
Via the
the module. The data type of the random values to be output is also defined by
this.
Cycle time
Via the
dom values shall be sent. Deactivate the associated control field if the values
are not to be sent out cyclically.
Lower limit
Via the
from which the random values shall originate.
Only send with change
Via the
value shall only be sent if the result of the calculation is different to the previ-
ously calculated result.
20.3.36.3 Conversion table
Boolean
(converted)
Boolean ---
0
Number
≠ 0
DPTTime true
DPTDate true
parameter, you can specify the internal data type of
parameter, you can specify in which intervals (seconds) ran-
Upper limit
and
true
→
→
false
parameters, you can specify the value range
parameter, you can specify whether an output
214/240