Activating The Baby Phone Receiver; Activating Logic Functions - Busch-Jaeger Busch-ComfortTouch Product Manual

125/240
The camera module is activated via Basic settings dialog.
This setting is located in theAdditional applications view
in Camera module field. The camera module is activated
when Yes is selected there.
You can use the internal camera in the corresponding ap-
plications if the key module is present on the device and
the software module with the same name is activated. Ad-
ditional settings are not required.
Note:
The default setting for access control is deactivated.
19.9.6 Activating the baby phone
receiver
Using the Baby phone application, cameras and micropho-
nes of other Comfort Panels in the network can be used,
for example, to monitor a sleeping baby in a children's
room. If the sound levels there exceed a set value, the Ba-
by phone application establishes an audio/video connection
to other selected panels. A panel must be configured as
Baby phone receiver so that it can receive the audio/video
data of a Baby phone monitor.
To do this, the additional Baby phone receiver application
must be activated in the Basic settings dialog. This setting
is located in Additional applications view in the Baby
phone field. Select Yes there.
After activating, you can configure the Baby phone recei-
ver (see Configuring a baby phone application
Note:
The Baby phone receiver is deactivated in the default set-
ting.
19.9.7

Activating logic functions

Complex switching sequences can be realised in the Com-
fort Panel using so-called Logic functions. However, these
can only be created in IP Project if the corresponding
software module has been activated first.
The logic functions are activated via Basic settings dialog.
This setting is located in view Additional applications in
the Logic editor field. Logic functions are activated when
Yes is selected.
After activating, you can configure the logic functions in
an editor (see here).
Note:
page).