Table of Contents
Advertisement
20
Configuring additional applications (Comfort Panel)
Comfort Panel applications whose configuration is more complex have a special editor window
in IP Project. You can access these via the respective buttons in the parameter area and via
Comfort Panel > Default settings in the menu:
when the required Comfort Panel is marked in the Project level or
when no other element is marked on the Navigation level.
20.1
→ Configuring the simulated presence
141/240
on telegram is received on Enable status for backlight, the object
Screen saver\Backlight status is active. If a switch-off telegram is
received on Enable status for backlight, the object Backlight sta-
tus is not active.
Screen saver\Backlight status
19.15.19
This 1-bit communication object is used to signal whether the
display backlight is switched on or off. When the display
backlight is switched on, a telegram with value 1 is sent, and a
telegram with value 0 is sent when it is switched off.
Note:
The communication object can be activated or deactivated via the
1-bit communication object Screen saver\Enable status for
backlight.
20.1.1
Using the simulated presence
Simulated presence can be used to record processes in the
house (e.g. switching of lights, adjusting blinds) while the
user is present (recording mode) and then carry them out
(playback mode) during the user's absence.
Recording mode:
The simulated presence records the telegrams of 20 objects
over the period of one week and stores these with week-
day, time, object number and value (1 bit/1 byte). If more
than one telegram arrives per object and minute, only the
last telegram is tested and stored. Only the change of state
is recorded, i.e. with telegrams of the same content only
the first one is recorded.
Up to 20 actions per day and object are recorded. If there
are more telegrams within a 24-hour period, the oldest
Advertisement
Table of Contents
