Table of Contents
Advertisement
19.7
→ Activating UPnP
19.8
→ Activating additional applications
19.9
→ Configuring additional applications
121/240
Parameter Activate UPnP service in dialogue Basic set-
tings under UPnP is used to to activate Universal Plug and
Play (UPnP).
The Comfort Panel depends on UPnP to open a UPnP port
and register itself in the UPnP network. This ability is re-
quired for sending and receiving a project from IPP via a
network.
19.8.1
Activating simulated presence
Simulated presence can be used to record processes in the
house (e.g. switching of lights, adjusting blinds) while the
user is present (recording mode) and then carry them out
(playback mode) during the user's absence.
Simulated presence does not have a visual control page on
the Comfort Panel but can only be accessed by the user via
the status bar. It is therefore activated via dialogue Basic
settings. This setting is located in view Additional applica-
tions in field Simulated presence. Simulated presence is
active when Yes is selected.
After activating, you can configure this application in an
editor (see
Configuring additional
Note:
The default setting for simulated presence is active.
19.9.1
Configuring simulated
presence
If simulated presence has been activated, the user has the
option of editing this function directly on the Comfort Pa-
nel. It would be practical to pre-configure simulated pre-
sence in the IP project. The respective editor can be called
up in the parameter section of the Comfort Panel via the
applications).
Advertisement
Table of Contents
