Table of Contents
Advertisement
113/240
the filter table.
KNX --> IP Group telegrams
19.5.3.2
main group 14+15
Via the KNX --> IP Group telegrams main group 14+15,
the transfer of group telegrams with main group addresses
14 and 15 from the Sub line to the Main/area line is blo-
cked or enabled. When selecting Filteronly telegrams with
main group addresses 14 and 15 that are listed in the filter
table are transferred.
IP --> KNX Group telegrams
19.5.3.3
main group 0-13
Via the parameter IP --> KNX Group telegrams main
group 0-13 is used to block or enable the transfer of group
telegrams from the Main/area line to the sub line. When
selecting Filter only telegrams that are listed in the filter
table are transferred.
KNX --> IP Group telegrams
19.5.3.4
main group 0-13
The parameter KNX --> IP Group telegrams main group
0-13 blocks or enables the transfer of group telegrams with
main group addresses 0 and 13 from the Sub line to the
Main/area line. When selecting Filteronly telegrams with
main group addresses 0 and 13 that are listed in the filter
table are transferred.
IP --> KNX Physically
19.5.3.5
addressed telegrams
Physical address
The IP --> KNX Physically addressed telegrams parameter
is used to set the transfer of physically addressed telegrams
from the main/area line to the sub line (e.g. programming
an application or for diagnostics purposes during the en-
quiry of the device state). Filter, Block and Transfer can be
set.
With the Transfer setting, the IP router only transfers tele-
grams with a physical address as target address if they
match the subordinate side (TP or PN connection of the IP
router). The IP router's own physical forms the basis for
the synchronisation.
Basis
(Tab
)
Basis
(Tab
)
Basis
(Tab
)
(Tab
)
Advertisement
Table of Contents
