• Change the mounting position of the clamp
switching slider according to the media width.
• When installed the clamp switch slider, clamps up,
and when removed, clamps down.
Connecting Cables
Connecting the LAN cable
When connecting LAN cable, be sure to follow the note
below:
• Surely insert LAN cable until clicking noise sounds.
Clamp switching
• Do not plug in or unplug any cable during data
slider
Printing Via a Network
If printing via a network, you need to configure your
network with the following environment.
If you configure it with an inappropriate environment, it
could cause printing to stop.
• Firmly insert until you hear a click.
• Do not plug or unplug the cable while data is being trans-
ferred.
• Use LAN cables that are category 6 or higher.
• Use a switching hub and PC that support 1000BASE-T.
If connecting directly to the printer
If connecting via a switching hub
If the PC or device connected to the printer is not
1000BASE-T, you cannot perform printing.
After connecting, check the following.
Chapter 1 Before Use
transferring.
• Set the PC sending the print data and the printer
to the same network.
• You cannot connect via a router.
Switching hub
1
2
2
2
5
6
1-9