Connecting Cables; Connecting The Lan Cable; Connecting Usb2.0 Interface Cable - MIMAKI JV300-130 A Operation Manual

Chapter 1 Before Use

Connecting Cables

Connecting the LAN cable

When connecting LAN cable, be sure to follow the note
below:
• Surely insert LAN cable until clicking noise
sounds.
• Do not plug in or unplug any cable during data
transferring.
Printing Via a Network
 Applicable model: Plus series
If printing via a network, you need to configure your
network with the following environment.
If you configure it with an inappropriate environment, it
could cause printing to stop.
• Use LAN cables that are category 6 or higher.
• Use a switching hub and PC that support 1000BASE-T.
• Set the PC sending the print data and the printer
to the same network.
• You cannot connect via a router.
● If connecting directly to the printer
● If connecting via a switching hub
Switching hub
If the PC or device connected to the printer is not
1000BASE-T, you cannot perform printing.
After connecting, check the following.
1-8
(1) Check the printer screen display.
• On the local screen or the media detection screen, press
the [Enter] key several times to display the information
screen.
• Check that "1000 Mbps" is displayed for the LAN status
item.
• If "100 Mbps", "10 Mbps", or "No connect" is
displayed, you cannot print using the LAN.
• If "100 Mbps" or "10 Mbps" is displayed, you can
use event mail (
mail function").
INFORMATION
LAN Status
(2) Check the green light of the LAN connector.
• After turning on the machine, the lamp for the LAN
connector will light up as follows.
Color State
Lighting Connected with 1000 BASE-T
Green
OFF Connected without 1000 BASE-T
Lighting Link-up
Yellow Blinking Receiving data
OFF Link-down
• If the yellow light only lights up, or is blinking, the
status is not 1000 Mbps. Check the specifications
of the PC, device, and cables.

Connecting USB2.0 Interface Cable

Connect the PC and this machine with the USB2.0
interface cable.
• Your RIP must be compatible with USB 2.0.
• Contact a RIP maker near your location or our
office when the USB2.0 interface is not attached
to the PC.
Chapter 3 "Enable the event
1000Mbps
Condition
USB cable