Table of Contents
Advertisement
Installation and Operation
Use a jumper cable to connect the library and the first tape
drive to one SCSI bus.
Connect the second host SCSI cable to the SCSI connector of
the second tape drive.
Install a terminator over the last device on each SCSI bus. In
the previous example, both tape drives are terminated.
library is a 120 VAC three-conductor power cord
for use in the United States and Canada. If you are
planning to use an input voltage other than
120 volts AC or if you plan to use the library outside
of the United States or Canada, you must supply
your ow n power cord. Refer to
information.
The pow er cord shipped with the
page 221
Installation and Setup
for more
51
Advertisement
Table of Contents
Need help?
Do you have a question about the 230D Library and is the answer not in the manual?
Questions and answers