Exabyte 230D Library Installation And Operation Manual page 252

Appendix C
could not move on its axis.
could not determine the home
position for the drum.
found multiple drum flags and
could not determine the drum
home position.
could not position the drum
because the reach axis was
extended too far.
could not reset the servo chip for
the drum axis.
could not read the bar code label
because there was no label on
the cartridge.
238
The drum
The library
The library
The library
The library
The bar code scanner
Open the door and look for anything
that might be obstructing the drum.
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
If the error persists, contact your
service provider.
Contact your service provider.
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
If the error persists, contact your
service provider.
Make sure the library and tape drives
are not being used by any host, then
reset the library using the operator
panel.
If the error persists, contact your
service provider.
This error appears on the Label
Information screen.
If the cartridge does not have a label,
place a label on the cartridge.
If the error persists, contact your
service provider.
Exabyte 230D