Exabyte 230D Library Installation And Operation Manual page 250

Appendix C
cartridge in the gripper before a
move operation or when the
operator powered-on or reset the
library.
could not successfully pick a
cartridge because it was still
loaded in the tape drive.
successfully pick from a full
cartridge slot.
occurred.
could not move along the reach
axis.
could not determine the home
position on its reach axis.
236
There was a
The robot
The robot could not
A gripper error
The robot
The robot
Remove the cartridge and put it back
in the magazine if you know where it
goes.
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
If the error persists, contact your
service provider.
Use the Open Tape Drive command on
the operator panel to unload the tape
drive. Or, redirect the robot to another
source location.
Open the door and look for anything
that might be obstructing the gripper.
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
If the error persists, contact your
service provider.
Open the door and look for anything
that might be obstructing the robot on
its reach axis.
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
If the error persists, contact your
service provider.
Exabyte 230D