Table of Contents
Advertisement
scanner could not read the bar
code label because the label was
unreadable.
scanner could not read the bar
code label because there was no
data cartridge magazine present.
could not be verified on a single
slot scan because the occupied
status was unknown.
code scanner could not read the
label because of a problem with
the checksum character.
Installation and Operation
The bar code
The bar code
Inventory
The bar
This error appears on the Label
Information screen.
If the cartridge has a label, reposition
or replace it.
If the label does not contain a
checksum character, make sure the
Verify Checksums option is OFF.
If the error persists, contact your
service provider.
This error appears on the Label
Information screen.
If necessary, install a data cartridge
magazine.
Make sure the library and tape drives
are not being used by any host, then
reset the library using the operator
panel.
If the error persists, contact your
service provider.
If the label does not contain a
checksum character, make sure the
Verify Checksum option is OFF. (See
page
90.)
Check the label for damage and
replace the label, if necessary.
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
If the error persists, contact your
service provider.
Error Codes
239
Advertisement
Table of Contents
Need help?
Do you have a question about the 230D Library and is the answer not in the manual?
Questions and answers