Exabyte 230D Library Installation And Operation Manual page 251

could not reset the servo chip for
the reach axis.
cannot push the cartridge far
enough to load the cartridge into
the tape drive.
could not move along the vertical
axis.
could not determine the home
position on the vertical axis.
could not reset the servo chip for
the vertical axis.
Installation and Operation
The library Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
If the error persists, contact your
service provider.
The robot Open the door and look for anything
that might be obstructing the robot
along its reach axis.
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
If the error persists, contact your
service provider.
The robot Open the door and look for anything
that might be obstructing the robot
along its vertical axis.
Make sure the library and tape drives
The robot
are not being used by any host, then
reset the library from the operator
panel.
If the error persists, contact your
service provider.
The library Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
If the error persists, contact your
service provider.
Error Codes
237